Code Module control software for electronic loads

Model Number: EES-DLL
DC Electronic Load Control Software Write your own control modules for vB6 & vB.NET
Use With:	1 or 2 Electronic Loads
Drives:	I2C ( Hardware EE301-I2C )
Drives:	I2C ( Hardware EE301-I2C-CABLE )
Drives:	Comes with DEMO source code
Drives:	PARALLEL PORT OF PC or CARD
Don't waste hours writing your own software and not have it work!
Use this software with the following manufactures of Loads


Need to write your own code interface	Control any Electronic Load can supports 2 channels
Use VB interface code to control the EES-DLL and control our electronic loads comes with VB source code for load control	EES-DLL comes with a complete Help Library to interface to our electronic loads & VB source code for load control
Complete systems starting at $1900.00
If you don't see what you want --- ask use ! We have special software that is not posted.

Works in demo mode without a key, Down Load & TRY IT

Specifications <--- CLICK HERE to open / Close
- software: File: Save / recall test setup for Software Setting
- software: settable Parallel port: I/O ( works with internal parallel cards also )
- software: File: settable data ranges
- software: offset: voltage corrections of hardware
- software: control: 0 - 20.000 / 40.000 / 80.000 Amps DC ( each channel )
- software: control: 0.000 - 50.000 / 150.000 Volts DC ( each channel )
- software: control: Standard: two ( 2 ) CHANNELS
- Communications: Parallel port Bus I/O: settable data bus speeds I2C
- Communications: Parallel port Bus I/O speed: < 0.2 ms per command
- Commands I/O: Program all function, cc, cr, cv, cp, V/I, data, timing, etc.
- Active X: DLL Runs in / Windows / DELPHI / LABVIEW
- HARDWARE: Requires Software key (supplied From Web Site)

Hardware & Software required for a system
Model Number for EES-DLL	Model Number for EE301-I2C	POWER CABLE / EE301-I2C-CABLE	ELECTRONIC LOAD
Standard SOFTWARE	Standard hARDWARE	Standard hARDWARE	Standard hARDWARE
1 Channel > EES-DLL	(QTY 1) EE301-I2C	(QTY 1) EE301-I2C-CABLE	(QTY 1) ALL MODELS
2 Channels > EES-DLL	(QTY 2) EE301-I2C	(QTY 1) EE301-I2C-CABLE	(QTY 2) ALL MODELS

NEW FREE..DEMO SOFTWARE ( EES-DLL ) Version 1.0 Work with I2C only

The EES-DLL is a new way of controlling an electronic load you can write your own Software and use our DLL to control the load.

DLL comes with example programs for VB6 & Executable program that really works

DLL I/O works with any parallel port and acts as a driver for the I2C I/O

DLL works with windows XP / 2000 / 98 / 95

DLL supports all Electronic Load types by Executive Engineering

What you need for a software system ELECTRONIC LOAD + EE301-I2C hardware for load control + EE301-I2C-CABLE this is a power and interface cable.