Model Number: EE106T-xx
Constant Power - Cable  for Electronic Loads
Volts:	12
Volts:	15-24
Current:	~100ma
Mode:	QSP

The EE106T is a pre-wired bias power cable designed to be used with the EE301xx & EE151xx series electronic loads. The cable allows you to connect the electronic load to a regulated 12Vdc bias power supply or by moving a wire use the 15-24 Volt unregulated input. The control pots on top of the electronic load are connected through this cable allowing you to adjust the startup voltage of the electronic load and current you desire at the electronic load. The cable also has the ability to be keyed so it can not be put in reverse for protection of the electronic loads circuits.

The cable is designed for stand alone operation of the electronic load. This cable allows the electronic loads 
qusi-power mode to operate unless the constant current option is installed in the load.  Then the load can also be operated in constant current. The cable length is 8" long.   
Plus 12 Vdc goes to ( pin 20 Red Wire)   or

Plus 15-24 goes to ( pin 4 Red Wire) 

Return 12 Vdc goes to (pin 2 Black Wire)\